Blendtec ez Blender Operations Instructions

operations manualBRAWN. BRAINS. BLENDTEC.™ez Blender

Page 8SECTION 5: OPERATING INSTRUCTIONS5.1 OPERATIONAL OVERVIEW1. Turn on the main power switch located on the back of the blender.2. Place the prope

Page 9 A reading of “OVERLOAD” indicates an overload on the motor. Turn the motor off for 10 seconds (using the switch) then turn the motor on again

Page 10● Increase cycle time. If the drink is mixing well but has not had enough time for complete blending, try a longer cycle (usually by using a h

Page 115.7 DAILY CLEANING OF MOTOR 1. Make sure the main power switch is off and motor is unplugged before cleaning.2. When necessary, wipe the metal

Page 12SECTION 6: WARRANTY AND SERVICE PROCEDURE6.1 WARRANTY DESCRIPTION Blendtec warrants the ez Blender base for 1 year or 5,000 cycles, whichever

Page 136.2 SERVICE PROCEDUREShould you experience any difculty in using your Blendtec blender, please do the following:UNDER WARRANTY1. Contact your

1206 South 1680 WestOrem, UT 84058801-222-0888www.blendtec.com OWN-CE-002 Manual, ez Blender Rev 01 07/06

Page 1Table Of ContentsSection PageSection 1 ...Important Safeguards 2Section 2...Component Overview 4Section 3...Unpacking 6Section

Page 2SECTION 1 – IMPORTANT SAFEGUARDS Read all instructions carefully before using your Blendtec machine.1.1 SAFETY CERTIFICATIONThe ez Blender and

Page 31.7 THE 110/120 VOLT RECEPTACLE FOR EACH POWER UNIT MUST BE PROTECTED BY A SEPARATE 15 AMP CIRCUIT BREAKER OR FUSE. Do not use any other ele

Page 4SECTION 2: COMPONENT OVERVIEW2.1 BLENDER MOTORThe blender motor consists of the blender base, touch pad control, and Liquid Crystal Display (LC

Page 5

Page 6SECTION 3: UNPACKINGSave the two foam inserts and all packaging for future storage or shipping. Save these instructions for future reference.3.

Page 7SECTION 4: INSTALLATION4.1 ez Blender Installation1. Place blender base on a at, clean, dry surface. 2. Make sure plug outlet is available wi